Every service we do, and the equipment behind it

Submersible Pump — Boring & Installation

We drill and case the borehole to the depth your site needs, then fit and commission the submersible pump set — this is the work our name is built on.

Equipment used

Pump Automation

Automation panels and float/level sensors are wired in so the pump starts and stops on its own — no manual switching, no dry-run risk.

Equipment used

Mono Block & Industrial Pumps

From single-phase mono block sets to larger industrial pump-and-motor combinations, we fit and service the equipment your site actually runs.

Equipment used

Rain Water Harvesting

Recharge pits and borewell-recharge fittings are built to route rainwater back underground, helping the water table recover over time.

Equipment used

Earthing

Earthing rods and cabling are installed to code for pump motors and control panels, so an electrical fault doesn't become a shock hazard.

Equipment used

Deburring

Cut pipes and fittings are deburred and cleaned before installation, so joints seal properly and don't leak or trap debris.

Equipment used

Pump Repairing

We open up, diagnose and repair submersible, mono block and industrial pumps on site or at our workshop, whatever the brand.

Equipment used